Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - WieBer18

Pages: [1]
General / Eigenschaften von Materialien
« on: September 17, 2019, 12:43 »

eine kurze Frage in die Runde.
Kann man den Projektmaterialien mehr als eine Eigenschaft hinterlegen?
Bisher habe ich z.B. nur das Gewicht angegeben.
Jetzt möchte ich aber gern Gewicht und Länge einem Material als Eigenschaft hinterlegen.
Ist das möglich?

Vielen Dank.

General / To program sequences/ loops
« on: September 09, 2019, 10:20 »
I have a question about a model that I have created.
This consists of three successive processes and in the last process a product is created (product X). However, if product X does not yet meet the specific requirements, it must go through the entire process again. In doing so, it is fed to the 1st process as input again. How can I inform the process that this product X should only be calculated if it did not fulfill the desired properties in the last process? In addition, a sequence of calculations must be specified in the 1st process, right? By that I mean a command such as "Calculate Formula One first. Do not calculate formula 2 until the following condition is met." Can these scenarios even be mapped to user-defined functions in Umberto?

Thank you very much.

P.s. Answers can also be written in German.

Pages: [1]