Author Topic: Changing Material Weight  (Read 2733 times)

Offline 1290JR1290

  • New Member
  • *
  • Posts: 2
    • View Profile
Changing Material Weight
« on: December 18, 2014, 17:34 »
Hello,

New here but doing a bit of this for my company, I set up an umberto design based on an estimated weight which was 2.5KG. I now need to change this to 390g. I have changed the "products" and all throughout the umberto however when calculating it still says 2500grams .. any idea what I need to amend ? I don't want to start again.

Thanks

Offline 1290JR1290

  • New Member
  • *
  • Posts: 2
    • View Profile
Re: Changing Material Weight
« Reply #1 on: December 18, 2014, 17:51 »
Sorted it. Thanks

Offline pbeilschmidt

  • Administrator
  • Hero Member
  • *****
  • Posts: 585
    • View Profile
Re: Changing Material Weight
« Reply #2 on: December 19, 2014, 08:51 »
For the other users reading here: The material flow network is calculated based on the manual flow (trigger flow). This is the flow you enter in one arrow of the model (it will then be shown in purple).
The manual flow quantity can be changed any time, just make sure that you do a new calculation to determine all flow values in the model based on the new manual flow quantity.
------------------------
Peter Müller-Beilschmidt
myUmberto Moderator
ifu Hamburg GmbH